When the Aluminum Clip is installed, the operator mainly judges whether the clip installation is in place by the feel and the sound, so the following points should be noted in the design:
Aluminum Clip
(1) Select the appropriate amount of deformation. The clip is mounted by deformation and bounce of the fastener. Too small deformation is easy to cause the installation is not strong; too much deformation is easy to cause installation difficulties or even installation, destroying the clip.
(2) When designing, pay attention to some obvious phenomena, such as changes in sound and feel, when the clip is installed.
(3) When designing, pay attention to the number of constraints of the clip, and there should be no over-constrained conditions. Too many constraints, high requirements on the machining accuracy of the parts. In the actual assembly process, it is easy to cause the installation to be out of place or not to be installed.
