When the Sausage Clipper is installed, the operator mainly judges whether the buckle installation is in place by the feel and sound, so the following points should be noted in the design:
1) Select the appropriate amount of deformation. The buckle is mounted by deformation and bounce of the fastener. Too small deformation is likely to cause the installation to be weak; too much deformation can easily lead to installation difficulties or even failure to install and damage the buckle.
2) When designing, pay attention to some obvious phenomena, such as changes in sound and feel, when the buckle is installed.
3) When designing, pay attention to the number of constraints of the Sausage Clip, and there should be no over-constrained conditions. Too many constraints, high requirements on the machining accuracy of the parts. In the actual assembly process, it is easy to cause the installation to be out of place or not to be installed.
