The Slurry Explosive Clips is a common connection method in our structural design, which is low in cost and cleverly designed. I summed up a few points to note:
1. Elasticity. This is too important, the buckle has no elasticity, it has lost its left and right, and the buckle is snapped by deformation. There are two factors influencing this deformation, one is the wall thickness of the buckle and the length of one buckle.
2. Pay attention to the width of the buckle, too long and not too good, too short and no strength.
3. Pay attention to the amount of the buckle. The amount of the buckle is changed according to the elasticity. It is also divided into a dead buckle and a live buckle. There are a lot of tutorials or online saying that the amount of the buckle is greater than or equal to 0.6mm is the dead button, less than or equal to the buckle. I personally understand that there is no need to get so dead, depending on the characteristics of the product and the elastic variables of the buckle. The following is a design clearance for the buckle, the buckle I think can start to make a reservation, and then add glue.
4, the Silicone Sealant Clipper is a learning, there are many ways, the most important thing is to master the elasticity, while ensuring the strength, mold shrinkage and row position and slanting top space.
