During the installation of the Aluminum Clip, the operator mainly determines whether the buckle is installed in place by hand feeling and sound. Therefore, the following points should be paid attention to in the design:
1) select the appropriate amount of deformation. Aluminum Wire Clips are installed by means of deformation and rebound of fasteners. And too small amount of deformation easy to cause the installation is not firm; Too large deformation and easy to lead to installation difficulties or even unable to install, damage buckle.
2) during the design, pay attention to make some obvious phenomena, such as changes in sound and feel, appear when the Great Wall buckle is installed.
3) during the design, pay attention to the number of constraints of the Great Wall buckle, and the constraint situation cannot occur. Too many constraints on the parts of the processing accuracy requirements. In the actual assembly process, easy to cause the installation is not in place or can not be installed.
If necessary, please contact the Aluminum Clip Supplier
