When the Tipper Tie Clips is installed, the operator mainly judges whether the buckle installation is in place by the feel and the sound. Therefore, the following points should be noted in the design:
1) Select the appropriate amount of deformation. The Great Wall snaps are installed by deformation and bounce of the fasteners. Too small deformation is easy to cause the installation is not strong; too much deformation is easy to cause installation difficulties or even installation, destroying the buckle.
2) When designing, pay attention to some obvious phenomena such as sound and feel changes when the Hog Ring Fastener Clips is installed.
3) When designing, pay attention to the number of constraints on the Great Wall buckle, and you should not be over-constrained. Too many constraints, high requirements on the machining accuracy of the parts. In the actual assembly process, it is easy to cause the installation to be out of place or not to be installed.
